Move to offset

The Go to Offset menu opens a dialog allowing specification of an exact location (offset) in the disk to jump to.

Figure 1: Go to Offset dialog

You can use both decimal and hexadecimal values, preceding hexadecimal values with 0x. For example, to specify location 512 as a hexadecimal number, enter 0x200. There are also options to specify an offset from the beginning, from the current position, or from the end.

Next to the offset edit field there are two labels specifying the minimum and maximum allowed vales for offsets displayed as decimal numbers.

You can also open this dialog directly by using the shortcut Ctrl+Shift+G.